Self Clean Mode
Press C
LEAN
to activate or deactivate the self−cleaning function.
Under this function, the air conditioner automatically cleans
and dries the evaporator. The cleaning cycle takes 16 minutes,
after which the unit turns off automatically. Press
CLEAN
on the
middle of the cycle to cancel the operation and turn off the unit.
This function can be activated only in the
COOL
or
DRY
mode.
Follow Me Mode
Press
FOLLOW ME
to activate or deactivate this function.
Under this setting, the temperature that appears in the
remote control is the actual temperature at its location. The
remote control sends this signal to the air conditioner every
3 minutes. This function is not available for
DRY
and
FAN
modes.
Freeze Protection Mode
Press
FP
for approximately 2 seconds to activate or
deactivate the
FREEZE PROTECTION
mode (heating set
back). The indoor unit displays “
FP
”.
NOTE: This function is only available in the heating mode.
Under this function, the unit operates at a high fan speed
and the coil temperature automatically sets to 46 F (8 C).
This mode can also be deactivated by pressing the “
On/
Off
”,
“Sleep”
,
“Mode”
,
“Fan”
, or either
“TEMP”
buttons.
Silence Mode
Press
SLC
to activate or deactivate the
SILENCE m
ode. Under
this function, the compressor operates at a low frequency
and the indoor unit produces a faint breeze, which reduces
the noise to the lowest level. Due to the low frequency
operation of the compressor, it may result in insufficient
cooling and heating capacity.
LED Light
Press
LED
to turn the display light on and off.
Resetting the Remote Control
If the batteries in the remote control are removed, the current
settings will be cancelled and the control returns to the initial
settings and will be in standby mode. Push the
ON/OFF
button to activate it.
Time Delay
If the
ON/OFF
button is pressed too soon after a
stop, the compressor will not start for 3 to 4 minutes
due to the inherent protection against frequent
compressor cycling. The unit only emits an audible beep
when the signals are received correctly.
Heating Features
If the unit is in the heating mode, there is a delay when
the fan starts. The fan starts only after the coil is warmed
up to prevent cold blow.
Auto Defrost Operation
In heating mode, if the outdoor coil is frosted, the indoor
fan and outdoor fan turns off while the system removes
the frost on the outdoor coil. The system automatically
reverts to normal operation when frost is removed from the
outdoor unit.
Auto Start
If the power fails while the unit is operating, the unit
stores the operating condition, and it will start operation
automatically under those conditions when the power is
restored.
Page
12
