Wiring
Page 35
Magnetic ring
(if supplied and packed with the
accessories)
1
2
3
Pass the belt through
the hole of the Magnetic
ring to fix it on the cable
4. Clamp down the cable with the cable clamp.
The cable must not be loose or pull on the
u-lugs.
5. Reattach the electric box cover.
CAUTION
•
While connecting the wires, please strictly
follow the wiring diagram.
•
The refrigerant circuit can become very hot.
Keep the interconnection cable away from
the copper tube.
Indoor Unit Wiring
1.
Prepare the cable for connection.
a. Using wire strippers, strip the rubber jacket
from both ends of the signal cable to reveal
about 15cm (5.9”) of the wire.
b.
Strip the insulation from the ends of the
wires.
c.
Using a wire crimper, crimp the u-lugs to
the ends of the wires.
2.
Remove the cover of the electric control box
on your indoor unit.
3.
Connect the u-lugs to the terminals.
Match the wire colors/labels with the labels
on the terminal block. Frmly screw the
u-lug of each wire to its corresponding
terminal. Refer to the Serial Number and
Wiring Diagram located on the cover of the
electric control box.
Connective wiring diagram
Wiring diagram
Control box
Please prepare spanner and
flat-blade
screwdriver
before your installation work .
Australia models
1. Remove two fixing screws, then remove the
front panel.
2 Screws
2. Use spanner and flat-blade screwdriver to knock
down two metal seals, then pick the metal flakes
out.
3. Connect the power cable and indoor & outdoor
connection cable. Clamp down the cable with
the cable clamp.
4. The wire groups shall be bound with cable ties
and fixed on the right side plate
after they are
connected. The strong electric wire group and
weak electric wire group shall be led out
separately through the two knock down holes
on the bottom of the right side plate and
fastened with a locking connector as shown in
the figure below.
