Automation Components, Inc.
2305 Pleasant View Road | Middleton, WI 53562
Phone:
1-888-967-5224 |
Website:
workaci.com
Page 2
Version: 4.0
I0000195
COVER
FIGURE 2:
MOUNTING
#6-32 x 1”
MOUNTING SCREWS
LCD MODULE
Must be unplugged before
the sensor is mounted
BACKPLATE
OPTIONAL INSULATING
GASKET
CIRCUIT BOARD
FIGURE 3:
SETPOINT PCB MOUNTED
ON BACKPLATE
0.63"
(16 mm)
TABLE 1:
PCB CONNECTIONS
TERMINAL BLOCKS
+
-
+ SET (located on back
PCB)
-SET (located on back
PCB)
O/R
O/R
CONNECTIONS
(+) 4 to 20 mA current loop input (Input to Display from Transmitter or Controller)
Note:
If Set Point, this wire will be factory installed.
(-) 4 to 20 mA LCD current loop output to controller analog input
+24VDC Supply Voltage
(-) 4 to 20 mA set point current loop output to controller analog input
Note:
This wire will be factory installed into the (-) Terminal Block
Override signal to controller analog input (N/O Dry Contact Closure)
Override signal common to controller analog input (N/O Dry Contact Closure)
Backplate
Setpoint
PCB
