MAINTENANCE OF DOOR PHONE
The main maintenance actions are cleaning and actions in connection of house renovation.
In daily use the door phone should be used carefully and firmly but in a gentle way.
Please do not use solvents when cleaning the device. Depending on the amount of use, the door phone
device should be cleaned couple of times in a year using a damp soft cloth and neutral cleaner. Clean door
phone is convenient to use, and it will stay clean and undamaged for long as people will handle it properly.
HOUSE RENOVATION ACTIONS
There are no user serviceable parts or changeable batteries or lights inside the door phone device. Anyway
if you are renovating the flat so that the phone device is in a risk to get painted or dusty, it is recommended
to remove it during the renovation and keeping it in a safe place. In addition, door phone device is not an
expensive part and it might often be a good solution to change it to a new one during the renovation.
It is not recommended to cover the device with adhesive tape during the renovation. In that case the old wall
material will be left at the background of the device. If the device will be changed to a new later the new
device might be smaller than the old one. A phone device which is protected by adhesive tape might be
stuck to the wall in which case it is not possible to detach it without damaging the wall. Sometimes the door
phone device is mounted to the wall by using acrylic mass. In general, it is recommended to remove the
phone device during the renovation as dust and dirty can damage it.
UNMOUNTING THE PHONE DEVICE
It's highly recommended to let a professional electrician to detach and mount the door phone device. There
It's highly recommended to let a professional electrician to detach and mount the door phone device. There
is no dangerous voltage inside the device but professionals have better qualifications for the operation.
Open the door phone device by opening the screw at the lower part of the handset using a cross head
Phillips 1 screwdriver (small cross head screwdriver) ) as shown in the picture. After that press the handset
cover at both sides and lift the lower end of the cover up. See below. When closing the cover, please follow
the instruction in reverse order.
In video door phone the wires are attached to quick connectors. So it is not necessary to detach the wires in
the connectors before pulling the connectors apart from the device. The connectors should be protected for
example by a plastic bag. If the wires need to be cut they should be first marked and documented and then
cut to 2 centimeters. When doing so the wire setup is marked in two places. The wires should be protected
for a short circuit using for example wire compression connectors (Dophin, Schotslock).
OPENING
CLOSING
When the device is opened and the wires are detached the device can be unmounted on the wall by opening
the fixing screws.
MOUNTING THE PHONE DEVICE
The phone device will be mounted in the wall. The cable can be led in at the back of the device, via the
wiring opening.
The wires are connected to connectors as they originally were. Close the phone device in the opposite
order: at first fasten the top edge of the cover using the small hooks there. Press the cover carefully to close
it and fix the screw. Make sure that the cover is properly in its place. After that check the proper functioning
by calling the device and testing all functions.
1
2
USER MANUAL OF THE ACET DOOR ENTRY SYSTEM
D10000431ENA
1
18.3.2013 JK/MK
