Acesonic UHF-1208XR, Руководство пользователя

Страница: 6 / 10

Microphone Descriptions
1) Cartridge module - This is where you would sing into.
2) Microphone body - The main frame of the microphone.
3) Operating indicator and
Hold the switch button for 1 second to turn on the power. Light will turns green means
microphone is now in working condition.
When it lights up green
,
then press switch button shortly
,
the light will turn yellow
,
means microphone is in mute mode
,
no sound will comes out from microphone
.
to
go back to working mode
,
press the switch button shortly again
,
the light will turn
green.
When IR syncing
,
microphone needs to stay power on
,
but can be either
working or mute mode
.
After switching channel on the receiver and start IR syncing
.
Then put the button part of the microphone to face the IR launcher on the receiver
,
the distance need to be under 1 meter
.
Press the microphone switch button shortly
to confirm the IR syncing
.
If IR sync successes, the CH in the LCD screen will stop
flashing and you can see the RF signal bar on the LCD screen.
5)Battery cover
6)IR
receiver & charging unit - This is the base of the microphone. The bottom part has
a IR receiving unit inside which receive the IR signal from receives to complete the
IR matching for microphone and receiver
.
4)Switch button-
Microphone Operation & Channel switching:
1
)
Install batteries into microphone handheld
.
2)Turn on microphone by pushing the switch towards, the indicator should turn green.
3)To mute the microphone, push the switch button shortly
,
the light will turns yellow
.
4)To turn off the microphone, push the switch button for about 1
~
2 seconds then release
it, the indicator light will turns off
.
5)If you are not going to use the microphone for a long period of time, turn off the
microphone and pull out the batteries to avoid deterioration and damage toward the
components.
6)
When IR syncing
,
microphone needs to stay power on
,
but can be either working
or mute mode
.
After switching channel and start IR syncing on the receiver
.
Put the
button part of the microphone to face the IR launcher on the receiver
,
the distance
need to be under 1 meter
.
Press the microphone switch button shortly to confirm the
IR syncing
.
if IR syncing got confirmed
,
the channel information on the LCD of
receiver will stop flashing and you can see the RF signal bar on the LCD screen.
* For quick microphone channel matching process, please see the note on the top of
receiver, or see page 7 for more detail
.
6
12
08
XR