Acer Extensa 500, Руководство по обслуживанию

Страница: 76 / 108

76 Troubleshooting
2. Connect the power adapter and check that power is supplied.
3. Disconnect the power adapter and install the charged battery pack; then
check that power is supplied by the battery pack.
If you suspect a power problem, see the appropriate power supply check in
the following list:
❑ “Check the Power Adapter” on page 76
❑ “Check the Battery Pack” on page 76
Check the Power Adapter
Unplug the power adapter cable from the computer and measure the output
voltage at the plug of the power adapter cable. See the following figure
1. If the voltage is not correct, replace the power adapter.
2. If the voltage is within the range, do the following:
❑ Replace the System board.
❑
If the problem is not corrected, see “Undetermined Problems” on page
86.
❑
If the voltage is not correct, go to the next step.
Note: An audible noise from the power adapter does not always indicate
a defect.
3. If the power problem occurs only when the port replicator is used, replace
the port replicator.
4. If the power-on indicator does not light up, check the power cord of the
power adapter for correct continuity and installation.
5. If the operational charge does not work, see “Check the Battery Pack” on
page 76.
Check the Battery Pack
To check the battery pack, do the following:
1. Power off the computer.
Pin 1: +19 to +20.5V
Pin 2: 0V, Ground