3.2 Adjust the Stem
To reset the stem, make sure that the centerline of the stem aligns with that of the front wheel.
Fasten the stem screw using the 5mm hex key, with the recommended torque between 6~8 Nm.
Apply a small amount of lubricating oil when tightening the screws to reduce friction during fastening.
3.3 Adjust the Brake Levers
Adjust the brake levers on both right and left sides to an appropriate location and fasten the screws with
the 4mm hex key, with the recommended torque between 6~8 Nm. Apply a small amount of lubricating oil
when tightening the screws to reduce friction during fastening.
3.4 Adjust the Height of the Saddle
You can measure your own inseam and adjust the saddle height based on it. After loosening the clamp
screw, adjust the saddle to an appropriate height for your legs to step on the ground while straddling and
then fasten the clamp screw tightly. The recommended torque is between 6~8 Nm. Apply a small amount of
lubricating oil when tightening the screws to reduce friction during fastening.
Notice :
1. If there’s a radar installed on your ebii 20, the fixation of the radar relies on the positioning after pushing down the clamp of seat post to set
the screw. Therefore, please do not loosen the securing screw of the radar while adjusting the saddle height to avoid radar swaying.
2. Please ensure the seat post is inserted in the seat tube by at least 10 cm.
3. You can adjust the saddle height based on your personal needs, but do not pull the seat post out beyond the minimum depth.
10
