Federal Communications Commission (FCC) Radio Frequency Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15
of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible for compliance could void the user's
authority to operate this equipment.
The user should not modify or change this device without written approval from ACE CAD Enterprise Co., Ltd.
Modification could void authority to use this equipment.
Caution
Using a mobile device while driving may cause distraction. End a call if you can
’t concentrate on driving. Also,
using a mobile device or accessory may be prohibited or restricted in certain areas. Always obey the laws and
regulations on the use of these products.
Trademark Information
ACECAD is a registered trademark of ACE CAD Enterprise Co., Ltd.
The Bluetooth word mark and logos are registered trademarks owned by Bluetooth SIG, Inc. and any use of such
marks by ACE CAD Enterprise Co., Ltd. is under license.
All other trademarks are the property of their respective owners.
Copyright Notice
© 2013 ACE CAD Enterprise Co., Ltd. All rights reserved. No part of this publication may be reproduced, stored in a
retrieval system, or transmitted, in any form or by any means (electronic, mechanical, photocopying, recording, or
otherwise), without the prior written permission of the publisher.
www.acecad.com.tw
