OPERATION INSTRUCTIONS
Important Operation Note:
Anytime the unit is unplugged or the power is turned off, allow at least five
(5) minutes before re-plugging or turning the power on.
Before using or placing any products inside the unit, it is
recommenced to let it operate for 1 to 2 days with the unit doors
closed, to insure the temperature reaches and stays within the set
points. This will also insure the unit is operating properly and there
are no shipping damages or issues with the cooling system.
As a reminder, the manufacturer warranty does not cover product
loss.
Be careful NOT to block the interior fans (air ducts) located on the
ceiling or the air-flow through interior back wall.
Blocking the air flow may cause decrease in performance & uneven
temperature through the unit interior.
For the best performance, maintain at least 4 inches of clearance
between the contents and the interior air duct / fans.
Use the shelves that comes with the unit and fit in correctly.
Do not leave the unit door open for a long period of time, close the
door immediately after each use, for optimum operation.
Interior Light Switch:
The light switch is located on the left side of side grill.
Digital Temperature controller:
The controller is programmed by the factory and set to the
recommended settings for the Kegerator unit and no adjustments are
needed.
Default lowest point temperature is set at “34" degrees with“7”
degrees of temperature differentials.
Changing the factory settings could lead to unit malfunction and
performance problems.
Contact the manufacturer or authorized dealer if there is an issue with
the temperature and the unit is not performing properly.
