Ace ACE-3205, Инструкция по установке и эксплуатации

Страница: 170 / 418

Chapter 4 Configuration Installation and Operation Manual
4-80 Configuring for Operation ACE-3105, ACE-3205 Ver. 5.2
Parameter Description Possible Values
•
IMA groups are available only for SHDSL.
• The port/group number cannot be changed
dynamically (on the fly).
1–5/9/17
VPI The channel’s VPI
Note:
• AAL5 VCL with the same VPI as an existing VC
XC cannot be configured on the same port.
• The VPI cannot be changed dynamically (on the
fly).
0–255
(if ACE configured as UNI,
max VPI bits = 8)
0–4095
(if ACE configured as NNI,
max VPI bits = 12)
VCI The channel’s VCI. For VP XC.
Note:
•
AAL5 VCL with the same VPI/VCI as an existing
VC XC cannot be configured on the same port.
• The VCI cannot be changed dynamically (on the
fly).
32–65535
Out TD The channel's traffic descriptor.
Note:
• The traffic descriptor must be created first.
• The traffic descriptor can be changed on the fly
as long as it belongs to the same service
category. The traffic descriptor’s PCR cannot be
higher than the output rate.
• TD with service category of CBR-CES cannot be
used.
• TD mode cannot be used with Policing.
1–99999
Default: 1
OD The CES channel's OAM descriptor.
Note:
• The OAM descriptor must be created first.
• OAM descriptor cannot be changed on the fly.
• The max number of Endpoints (Vcl/Vpl) with OD
with OAM Loopback ‘On’ is 128.
1–256
Default: 1