Ace ACE-3105, Инструкция по установке и эксплуатации

Страница: 183 / 418

Installation and Operation Manual Chapter 4 Configuration
ACE-3105, ACE-3205 Ver. 5.2 Configuring for Operation 4-93
ACE-3205 – RAD Data Communications
Configuration> Applications> Router> Static route
1. IP address ... (0.0.0.0)
2. IP mask ... (0.0.0.0)
3. Next hop ... (0.0.0.0)
4. Next hop interface number ... (0)
>
Please select item <1 to 4>
ESC-previous menu; !-main menu; &-exit
Figure 4-65. Static Route Menu
Table 4-58. Static Route Parameters
Parameter Description Possible Values
IP address IP address of the static route subnet or
station.
It is possible to enter a multicast address
to support multicast clock distribution.
0.0.0.0 –
255.255.255.255
(any legal IP address)
IP mask IP mask of the static route subnet. 0.0.0.0 –
255.255.255.255
(any legal IP mask)
Next hop IP address of the next hop. Must belong to
the router interface's subnet.
Note:
• Multicast, broadcast or all ones address is
not allowed.
•
All zeros cannot be assigned to an
address part that is not the router
interface's subnet.
•
If 0.0.0.0 is used, it indicates that the
routing is based on the next hop interface
number. This kind of setting is useful
when the router interface is of an ATM VC
type, PW or PPPoE type.
0.0.0.0 –
255.255.255.255
Default: 0.0.0.0
Next hop
interface
number ID number of the router interface towards
which the destination subnet should be
router.
Available only if the next hop is 0.0.0.0.
A number of a
previously configured
router interface. For
more information,
see
Configuring the
Router Interface
.
•
The number of static routes is limited to 81.
•
A static route cannot be deleted when it is used as a route of an existing peer.
Note