Ace ACE-3105, Инструкция по установке и эксплуатации

Страница: 166 / 418

Chapter 4 Configuration Installation and Operation Manual
4-76 Configuring for Operation ACE-3105, ACE-3205 Ver. 5.2
Parameter Description Possible Values
VCI The channel’s VCI for VC XC (valid only for a VC XC).
Note:
• Must be identical to the one configured for the
port.
• VP and VC XC with the same VPI on the same
port cannot be configured.
• Two VP XC with the same VPI on the same port
cannot be configured.
•
Two VC XC with the same VPI/VCI on the same
port cannot be configured.
• When a VP/VC XC configuration uses an existing
VPL/VCL that is not part of a VP/VC XC, the
VPL/VCL should be modified respectively.
32–65535
IN TD The channel’s policing traffic descriptor.
Note:
• The traffic descriptor must be created first.
• Traffic descriptor can be changed on the fly as
long as it has the same service category
• While the In TD is set to 0, the policing for the
selected ATM channel will be stopped.
0–99999
Default: 0
OUT TD The channel’s traffic descriptor.
Note:
•
The traffic descriptor must be created first.
•
Traffic descriptor can be changed on the fly as
long as it has the same service category.
• Traffic descriptor’s PCR cannot be higher than
the output rate.
• TD with service category of CBR-CES can’t be
used.
1–99999
Default: 1
OD The channel’s OAM descriptor.
Note:
• The OAM descriptor must be created first.
• The OAM descriptor cannot be changed on the
fly.
• The OAM descriptor mode can’t be end-to-end.
• The max number of Endpoints (Vcl/Vpl) with OD
with OAM Loopback ‘On’ is 128.
1–256/2048 (max XC * 2)
Default: 1
Congestion control The channel’s congestion control mode. None
• Items 3–9 and items 10–16 appear on two separate columns under the ATM
XC menu (see
Figure 4-55 ).
•
All items, except XC ID (item no. 2) and TD (item no. 7) – cannot be changed
dynamically (on-the-fly).
Note