9/
2
8
/20
22
ACE130
19
Power Supply Module
Location: The power supply module is located in the rear, upper portion of the chassis.
Type and number of fastenings: Four (4) Phillips Screws per module.
Tools required: Screwdriver
Procedure:
Step 1: Step 1: Ensure the computer is off, unplugged, and any
potential energy is dissipated.
Step 2: Remove the side panel from the chassis as indicated in
the “Chassis Cover” section of this manual.
Step 3: Remove the four exterior Phillips screws, be sure to
support the power supply once the screws are removed there will
no longer be anything to support the power supply.
Step 4: Remove all electrical connections from the various
internal components as applicable.
Step 5: Gently slide the power supply out of the case.
When removing the connectors from the motherboard
use caution, some connectors have latching clips and if
not removed properly can be damaged during the removal
process. See photo below for reference.
Reinstallation
Step 6: When reinstalling the power supply be sure
to use care not to hit or damage other components
in the system.
Step 7: Position the power supply in the upper left-
hand corner of the chassis, aligning the holes of the
power supply with the rear screw holes of the
chassis.
Step 8: Use a PH2 Phillips screw bit, tighten the screws to secure the power supply in place.
Step 9: Reconnect the required power cables. Depending on the configuration of system this
may vary, but the basic system required connection of the following:
