Acdeos AXS FL, Конденсированное руководство

Страница: 12 / 16

12
Check that the red LED on the dashboard turns red when the step is out.
Check that the buzzer works while the step is moving in or out. (If not disconnected)
4.
SAFETY FUNCTION
– Move the step out and try to stop it with your hand. The step should
stop, move back, and come out again. It will try this 3 times, then it will stop. It should go
back in after closing the door.
5.
INTERLOCK VEHICLE
– Release the vehicle handbrake, then try to operate the step. It
should not be possible to operate it. (unless the handbrake interlock is not installed)
6.2.3 Yearly maintenance / normal maintenance
A thorough maintenance check should be done once every year or at least every 10.000
cycles.
We recommend reduce the maintenance period to 6 months when the step is used in hard
conditions with much snow / ice / mud / gravel etc,
Normal maintenance:
Bring the step in the out position. Remove the bottom plate screws. Remove the bottom plate
by lifting it with a flat head screwdriver.
•
Check all moving parts like, arm gears, push
rods and wheels for excessive play. If there is
excessive play on moving parts it is
recommended to replace these parts.
•
Check the adjustment of the in and out switch.
•
Check wires and electrical connections for
possible failures.
•
Clean all parts
•
Grease moving parts with MOTIP White
PTFE grease or normal bearing grease.
Close the bottom plate.
With step still in out position remove ty-rap at the rear of the
step from both rubber end caps.
Spray a good grease in the tube or use normal bearing
grease with a long brush. This is the most important part
of the maintenance.
Close rubber caps again and fit with a new Tie-wrap
We strongly recommend MOTIP White PTFE grease part
nr 090204 for all parts in the step,
do not
use WD40 or
silicon sprays
Other similar PTFE grease sprays can also be used.
This spray is also available at Acdeos under part number
S150 310