DS210_HardwareDocu_V1.50_EN.doc
15 / 20
5.4 Hardware configuration ACD DS210 ISDN
The ACD DS210 ISDN is delivered with integrated ISDN Adapter. In this version the DS210 can charge a
M210, charge one replacement battery, data can be transferred from the M210 either directly via USB
interface to a PC, or per remote data transfer to a ISDN adapter. Plug the ISDN cable into the RJ45
connector without LED at the back of the unit on the right. Due to RTS/CTS – control lines you can
communicate with the ISDN adapter with hardwareshake. The ISDN adapter is activated via virtual COM port
driver at COM5. The ISDN adapter is reset when the M210 is placed in the DS210. Furthermore it is possible
to connect a USB end device e.g. a USB memory stick to the USB-A connector.
Pic. 11: ACD DS210 ISDN
Connections from left to right:
•
Connection power supply pack.
•
The USB-B connector is occupied according to USB standard. Usual USB-A-B cables can be connected.
•
The USB-A connector is also occupied according to USB Standard. According to the application usual
USB A-B, USB A-miniB cable, USB A-plug – A-connector extension cable or a USB stick can be
connected.
•
A usual ISDN cable can be connected to the RJ45 connector at the right
The ISDN adapter is configured by ACD as follows:
&F
Presetting (see ISDN adapter manual)
S0=0
ISDN adapter does not answer incoming calls
&D2
ISDN adapter hangs up in dependence of DTR
X3
After connection establishment the message „CONNECT“ is displayed with the
corresponding connection speed. The message „NO DIALTONE“ is not displayed.
&K3
RTS/CTS modem flow control (hardwarehandshake)
ACD provides an ISDN adapter manual.
USB-B
USB-A
Connect. Power
supply pack
ISDN RJ45
