ACD GRUPPE MFT1 Series, Краткий обзор

Страница: 17 / 23

MFT1x_Kurzübersicht_Brief Overview_V2.22_de_en 17 / 23
12 Handling of the Device
12.1 Switching the Device On and Off
12.1.1 By keys
When in standard mode, the device is switched on via the OK button
and is switched off by pressing the F1
button for at least 5 seconds. If the device is in standby mode, this is indicated by the flashing of the green
LED (3 seconds off/1 second on).
Via the MFT10Tray application it is possible to configure the following combinations to switch the device on
and off. The MFT10Tray is only available under Windows
®
. Vehicle terminals with the Android
TM
operating
system use the pre-installed ACD TerminalSettings application to make settings (see documentation:
"Android_Manual_Adminstration_Administration_Manual").
Setting Function
Switch
on
(ATX on) No key Immediately switched on without pressing any button
F1 Via the F1 button
F2 Via the F2 button
OK Via the OK button
OK+F1 Via the OK button and simultaneous after this pressing of the
F1 button within 2 seconds. (The OK button must be kept
pressed while doing so)
OK+F2 Via the OK button and simultaneous after this pressing of the
F2 button within 2 seconds. (The OK button must be kept
pressed while doing so)
Switch
off
(ATX off) No key No shutdown via any pressed button
F1 By pressing the F1 button for at least 5 seconds
F2 By pressing the F2 button for at least 5 seconds
12.1.2 By Ignition
The hardware of the ignition is explained in chapter 12.3.1.
The ignition can be used via an additional signal (voltage supply cable).
The ignition is used in “parallel” to the "By keys" function. Configuration is carried out in the MFT10Tray
application (see document
“MFT10Tray”) or under the Android
TM
operating system with the ACD
TerminalSettings application (see documentation: "Android_Manual_Adminstration_Administration_Manual").
By using the ignition signal, the MFT can be started (switched on) or shut down (switched off).
There are two ways to use the ignition signal: continuously switched (MFT10Tray/ACD TerminalSettings:
“Static”) or button (MFT10Tray/ACD TerminalSettings: "Toggle"). For the steady state On or Off, a debounce
time of 0.5 seconds is effective.
static : With an active signal from the ignition the MFT is switched on. Subsequently, the signal must remain
active. When the signal is removed (signal state low) the MFT is shut down (if so configured).
toggle : With an active signal from the ignition (longer than 0.5 seconds) the MFT is switched on.
Subsequently, the signal can be inactive (low state). Via another active state (longer than 0.5 seconds) the
MFT is shut down.
Upon delivery of the MFT by ACD, the ignition is configured as requested by the customer.