READ CAREFULLY
TO INFLATE TIRES
Fig. 1
Fig. 2
Fig. 3
FOR INFLATABLES
Unless directions are followed, physical injury or property damage may result.
When using the compressor, never leave it unattended.
Power required: 12 volts 10 amps. D.C.
This compressor is designed for occasional use only. Operation over an
extended period of time will overheat the unit and damage the compressor.
A sluggish operation of the compressor or if the exposed metal fittings
get too warm to the touch should indicate to you that the unit has been
operating too long and is overheating. When this occurs stop the unit
immediately, and let it cool for approximately 30 minutes before resuming
operation.
You may use a 12 volt battery charger to power this compressor, but it
must be rated at 10 amps or more to avoid damage to the compressor
and for the charger.
Do not use air inflator on high pressure tires such as those used on large
trucks.
Place connector on input valve stem (Fig.1) and push down. Close thumb
latch connector (Fig.2). Caution: Make sure the connector always touches
the core of tire valve stem.
Plug power cord into cigarette lighter receptacle.(Fig.3)
Then set compressor on/off switch to "on" position.
When proper pressure is reached, set on/off switch to "off" position, unplug
power cord and remove connector.
Select the suitable adapter and insert it into the connector. (Fig. 4) Close
thumb latch.
1.
2.
3.
4.
1.
2.
3.
1.
2
