Accutech WI-ANT-P6, Руководство пользователя

Страница: 8 / 16

Warning! Always use caution when installing this antenna. You can
be seriously injured if this antenna comes near or in contact with a
power line. Follow all local and national electrical code
requirements when installing the Base Radio with the high gain
antenna.
[1] Select the locations for the high gain antenna, the lightning
arrestor and Base Radio.
It is recommended that the lightning arrestor be mounted in close
proximity to the building egress. The lightning arrestor should be
mounted indoors unless you have the weatherproof enclosure.
The location for the high gain antenna should be selected based
on optimal positioning for RF communications with the field units
and allow for sufficient length of coaxial cable to reach the building
egress.
The Base Radio should be installed in a location where there is
sufficient coaxial cable available to reach the building egress.
Warning! Any Base Radio with an omni-directional antenna is for
ordinary locations only.
[2] Position the antenna so
that the gold sleeve clears
any obstructions. This
includes masts and tower
sections.
[3] Mount the antenna using
the 2 mounting brackets.
One clamp must be
placed at the center of the
gold sleeve, the other at
any point below.
[4] Connect the Base Radio coaxial cable to the lightning arrestor and
tighten by hand.
[5] Attach the ground wire to a suitable earth ground connection. Keep
this wire as short as possible. Make sure this connection conforms
to electrical code requirements.
[6] Connect the lightning arrestor coaxial cable to the antenna and
hand-tighten.
[7] Install a drip loop in the cable to insure proper drainage.
Accutech High Gain Omni-Directional Remote Antenna User Guide Rev 0505 4