Accutech LC 1200, Руководство пользователя

Страница: 40 / 156

3-6 Tags & TAD LC 1200 Manual
Using the TAD to activate/deactivate Tags
To activate/deactivate Tags using the TAD (
Figure 3.6
and 3.7
), use the following instructions:
1. With no Tag in the TAD, slide the Power
switch to the On position. The TAD Power
LED illuminates. If it doesn’t, check the TAD’s
9-volt battery.
NOTE: If a Tag is in the receptacle and the
power to the TAD is cycled, the Tag may be
turned on or off unintentionally.
2. Place the Tag into the tag receptacle on the
back of the TAD unit in proper orientation for
the Tag type (Figure 3.7).
3. The Signal Strength LEDs on the TAD indicate
the current state (on or off) of the Tag.
4. The Signal Strength LEDs indicate:
a. Tag is Very Near – A Tag is very close
to the TAD (within approximately 6
inches).
b. Tag in Area – A Tag is nearby the
TAD (within approximately 2 feet)
5. To change the state of a Tag (from either on to
off or off to on), press and release the “ TAD”
button. The WAIT LED will illuminate for
about a second (Do not remove Tag while
WAIT LED is on) and the Signal Strength
LEDs will change accordingly.
6. Once activated, if the “Active Band Removal
or Low Battery on Tag” LED blinks (indicating
low Tag battery), the Tag should be replaced.
7.
Turn off the TAD.
Figure 3.7 Proper Tag orientation