ACCUDUAL
ACD-76300/ACD-76301/ACD-76302 RAID BOX
Follow the instructions provided below to configure the system interface setup
depending on type of RAID box
Configure the SCSI channel
The Default SCSI configuration as
shown on the figure. The default SCSI
ID is 6.
If you intend to configure the SCSI
channel to different ID number, please
refer the table. And leave others setting
as default if unnecessary.
*
The SCSI ID 7 usually reserved for
SCSI host controller, please avoid
using ID 7 for ACD-76301 box for
preventing the ID conflict.
ID
0
1
2
3
4
5
6
7
SW1
OFF ON OFF ON OFF ON OFF ON
SW2
OFF OFF ON ON OFF OFF ON ON
SW3
OFF OFF OFF OFF ON ON
ON ON
Configure the IDE channel
An IDE bus supports 2 devices in one
channel. The default IDE is set as
“master”.
If you intend to configure the device to
other setting, please remove and
change the cap according the
instruction figure.
Mount or Remove hard drive
Install hard drive into disk tray and secure the hard
drive by screws from the bottom.