9
6 Reproduction of a CD
6.1 Start-up and loading a CD
First of all switch-on the device by pressing the mains power switch
2
and set the rotary switch
10
to the
position
OPERATE
and the blue LED
7
in the middle lights up. The laser unit of the DRIVE I
– MK 2 now
initialises for approx. 2 seconds and finds out if a CD is loaded or not. If no CD is inserted, then the
display shows
NO disc
. If there is a CD in the device, then after initialisation of the laser the number of
music tracks and the total time of the CD are displayed. Then, for example, the display shows
10 65:20
.
This means that the inserted CD has 10 music tracks and the complete total playing time is 65 minutes
and 20 seconds.
If you wish to load a CD or exchange a CD which is already loaded, then first of all slowly push the cover
11
to the back. On the display there now appears
Open
, indicating the cover is open. Now remove
the clamper
12
by lifting it upwards. Please note that the clamper has an integrated magnet and therefore
sits rather firmly on the CD. After removing the clamper you may now remove a CD. When removing the
CD take care not to touch the laser unit. Finger prints and dirt on the laser unit can disturb the scanning
process and so negatively affect the sound.
Insert the desired CD and now place the clamper
12
in the middle of the CD. Make sure that the clamper
locks correctly into position, otherwise playback is not possible. Close the cover
11
completely again.
After the closing process the laser initialises again, i.e. it scans the inserted CD and determines the
number of music tracks as well as the total time. If no CD is loaded or the clamper
12
is not correctly
fixed on to the CD, the display shows
No disc
.
6.2 Basic functions of the DRIVE I
–
MK 2
After the CD has been correctly inserted the device is now ready for operation and you can start the CD
by shortly pressing the push button
PLAY
.
To stop the CD please press the push button
STOP
.
To jump or go to the next track please use the left rotary switch
SKIP
by shortly turning it clockwise and
then release. Should you wish to jump back one or several tracks, turn the rotary switch once or several
times shortly to the left (anticlockwise).
Should you wish to interrupt your music listening for a short time (e.g. a number of minutes or a just for a
few hours), operate the right rotary switch
10
and turn it left to the
STANDBY
position. In the standby
function now only the blue standby LED
8
is lit. The lighting for the upper logo and the display goes out.
For a complete start-up of the DRIVE I
– MK 2, set the rotary switch
10
again to the position
OPERATE
.
IMPORTANT SAFETY PRECAUTIONS:
If you wish to discontinue your music listening for a longer period (more than 1 hour) the device
must be completely disconnected from the mains power and this is done by pressing the mains
power switch
2
.
The functions
SKIP
,
STOP
and
PLAY
can also be operated using the IR remote control. The functions
STANDBY
and
OPERATE
are not available via the remote control.
