Speaker Terminals
Speaker wire can be inserted into the hole in the shaft of the speaker’s and transmitter terminals. Simply
strip away approximately 10mm of the wire jacket, push the connection terminal in and insert the wire
through the hole in the shaft. Release the terminal and it holds the speaker wire in place. Make sure no
stray wire strands touch the opposite terminal. If a wire is loose, it can cause a crackling or static type
sound that can be heard through the speaker. If it comes loose and touches the other terminal, it can
cause your receiver to go into protection mode.
Front Speaker Connections
On the back of the 2 front speakers are 2 push in connection terminals. Red is positive (+) and Black is
negative (-). From your receiver’s positive terminal connect the speaker wire to the (+) mark which is the
Red terminal on the speaker. Push the terminal in and insert the wire into the hole. Release the terminal
and the wire is connected. Connect the negative (-) wire to the Black terminal.
Centre Speaker / Wireless Transmitter
On the back of the transmitter there are 3 sets of speaker connections. Look at the wiring diagram on
page 3 for the connections. Connect speaker wire from your receiver’s surround speaker terminals and
the centre speaker terminals to the left and right inputs and centre input on the transmitter. Please ensure
that the left surround output goes to the left surround input and the same for the right side. Do the same
with the centre speaker connection. Make sure the po to + and - to - is correct or you will not get
true left and right surround sound. .
Power Switch
There is a 2 pin power socket on the right side of the centre/transmitter. Plug the power cable supplied in.
There is a power switch. Turn this on and leave it on as this goes to standby when the system is not
being used.
Wireless Transmitter
The wireless transmitter works on 2.4000GH to 2.4835GH. The transmitter finds a clear channel if you
have interference with cordless hand phones, wireless internet or microwave ovens.
Wireless Surround Speaker Connection
Plug the surround speakers into the power. Turn on the rear power switch and set the volume control at
zero. This can be adjusted to fine tune later. Make sure the speakers are in the correct position. When
you are looking at the TV the right surround is over your Right shoulder. When you are not using the
system for a long period or go on holidays, turn the power switch to
off
on the back of each surround
speaker.
Wireless Transmitter Surround set up
To get connected turn your receiver on and have a movie or music playing. If you have a setting called All
Channel on your receiver, use this for the set up as it will give you sound in all the speakers. After the set
up you can go back to digital from your DVD player or HD free to air or Foxtel. If you play a 5.1 movie you
may not get sound out of the wireless surround speakers unless the movie is producing sound from the
surround speakers.
4
Wireless Transmitter Rear Panel
Subwoofer Connection
Wireless Receiver
Speaker Terminal Connection
5
