2
Installation Instructions
Overlay Doors
1. Locate lock assembly by placing the installation jig against the
edge of the cabinet at the position desired (Figure 1).
2. Attach the lock assembly to the cabinet using the appropriate
mounting screws for your application (Figure 1).
WARNING!
Before installing the lock, you must
have access to the manual override lever or the
activation device connected.
Otherwise, you will
not be able to unlock and open the door.
Figure 1. Overlay Doors
Figure 2. Overlay Doors
Cable
Installation jig
Figure 3. Overlay Doors
Figure 4. Overlay Doors
3. Install the cable to the connector located at the back of the lock
assembly. Perform the electrical installation and
make sure the
lock assembly locks and unlocks properly before closing
the door
(Figure 2).
4. Remove one side of the backing from the double-sided tape and
apply the tape to the door strike component.
5. With the lock in the closed position, peel the backing off of the
double-sided tape on the door strike component.
6. Close the door and firmly apply pressure to ensure the door
striker adheres to the door (Figure 3).
7. Disengage the lock from its closed position using the activation
device or manual override.
8. Open the door and remove the installation jig. Attach the door
striker using the appropriate flat-head mounting screws for your
application (Figure 4).
Inset Doors
1. Drill pilot holes into your cabinet according to Figure 5. Be sure
to take panel thickness into consideration.
2. Drill pilot holes into the door according to Figure 6.
3. Install the cable to the connector located at the back of the lock
assembly. Perform the electrical installation and
make sure the lock
assembly locks and unlocks properly before closing the door
.
4. Fasten lock and door strike respectively, using the appropriate
mounting hardware for your application. See Figures 6 and 7.
Installation jig
Access to
manual override
Be sure you have
access to the manual
override lever or
activation device.
Min gap 1/8"
