2
Radio-controlled Time Setting
Important notes:
•
It can help to place the display console near an open window when carrying out the above.
•
When searching for the radio-controlled time signal, the display screen will be dimmed.
In Normal mode, press
MODE
button to start or stop receiving the radio-controlled time signal.
When successfully receiving the DCF RCC signal, set the time zone for the UK:
1. Press and hold the MODE button for approximately three seconds to enter the Time Setting mode. Digits to
be set will flash.
2. Press the DOWN button once to set the time zone to "-1".
3. Exit the setting mode and the correct UK time will be shown.
Manual Time Setting
1. Press and hold the
MODE
button for approximately three seconds to enter time setting mode.
2. Digits to be set are flashing.
3. Press
UP
or
DOWN
button to change the value.
4. Press the
MODE
button to confirm and continue to the next setting.
5. Finally press the
MODE
button to save the settings and exit the setting mode.
Settings order: Time zone > 24hr/12hr > Hours > Minutes > Year > Month > Day > °C/°F
> Barometric unit >
Language for week display > Country > City.
Alarm Time Setting
1. In Normal mode, press the
ALARM
button once to enter the Alarm mode.
2. In Alarm mode, press
ALARM
button again to turn on or turn off the Alarm.
3. In Alarm mode, press and hold the
ALARM
button for approximately three seconds to enter the Alarm time
setting mode. Digits to be set are flashing. Press
UP
or
DOWN
button to change the value. Press
MODE
button to confirm and continue to the next setting. Settings order: Hour > Minute.
In Alarm mode, Press the
MODE
button to return to Normal mode.
MAX/MIN Temperature and Humidity
1. In normal mode, Press the
UP
button to check the Max and Min temperature and humidity records.
2. In Max/Min temperature and humidity mode, press and hold the
UP
button for approximately three seconds
to clear the record.
Replacing Transmitter Batteries / Receive New Readings
If you have replaced the batteries on a remote transmitter, or would like to receive updated readings, press
and hold the
DOWN
button for approximately three seconds. After three
seconds, you will see “---“. Regaining
new readings can take up to three minutes.
SNZ/LIGHT
1. Press the SNZ/LIGHT button once to turn on the backlight for 10 seconds.
2. When the alarm rings, press the SNZ/LIGHT button to enter the snooze function.
