Prepared By: Tim Wojo
Revision - Date: 0 – 20080430
Page 7 of 16
40-6680 Service Manual
1. Using a Phillips screwdriver, remove 4 cross-slot sunk screws
M2.5×5(5-11-2), then remove three support rods (5-11-1).
2. Note: there are two kinds of these three connecting poles. Two poles with
M2 screw holes are in the front (see figure 12).
3. Using a Phillips screwdriver, remove 2 cross-slot plate screws
M2×3(5-11-3), then remove off the buzzer module (5-11-4).
4. Using a Phillips screwdriver, remove 3 cross plate screws M2×6 (5-11-5),
then remove partition ring (5-11-6). Reference figure 13.
5. Using a Phillips screwdriver, remove 2 cross plate screws M2×4(5-11-7),
then remove limit-position cover (5-11-8).
6. Take out 6 magnets (5-11-9)
Note: Polarities of two adjacent magnets are reverse
7. Using a Phillips screwdriver, remove 4 cross plate screws
M2×4(5-11-13), then remove the axis base (5-11-12) and axis
module (5-11-11).
5- 11- 2
5- 11- 1
5- 11- 3
5- 11- 4
5- 11- 5
5- 11- 6
5- 11- 7
5- 11- 8
5- 11- 9
5- 11- 10
5- 11- 12
5- 11- 11
5- 11- 13
Figure 12
Figure 13
Figure 14
