User-Maintenance Instructions
An AccuCut machine is easy to maintain. To keep it cutting efficiently, simply replace two parts periodically, and
keep dies free of lint and scraps. It couldn’t be simpler!
Replacement Parts
The roller applies even, preset pressure directly onto the die, causing the blade in the die to cut up through the
paper and into the roller. That pressure causes eventual wear of two consumable machine parts: the roller and
the die tray.
How to Replace the AccuCut Roller
Look for the “How to Replace Roller” sticker on the side of your machine for easy reference while replacing
roller. (See page 3 for location of sticker.)
USER-MAINTENANCE INSTRUCTIONS
8
STEP 1
Remove Safety Guard & Cover Plate
Grasp and squeeze safety guard with
both hands and lift straight up. Use
the
3
⁄
32
" hex wrench to remove the
two screws in the metal cover plate
without the handle. Set screws aside
and remove cover plate.
STEP 2
Remove Old Roller & Install New Roller
Pull roller out and discard. Slide
new roller in and set into position
by fitting metal shaft into opening
on opposite side of machine. Rotate
roller until it locks into end of shaft
and the handle turns with the roller.
STEP 3
Replace Cover Plate & Safety Guard
Make sure sides of guard slide inside
locking pins.
Replace roller and tray
once a year, depending on use. To order,
call AccuCut Customer Service at
800-288-1670/402-721-4134.
The roller is cut repeatedly
by the blades. It eventually
turns white and wears
away incrementally in the
areas where you do the
most cutting.
(MARK III
™
Item 404311;
MARK IV
™
Item 404310)
The die tray, which receives
the pressure of cutting,
eventually becomes slightly
warped. This happens for
most users after a year or
more of use.
(MARK III
™
Item 406102;
MARK IV
™
Item 406100)
Replace roller and die tray when…
• You are not able to cut the number of layers of paper and other materials listed on page 4.
• The roller has turned light gray or white.
• The tray bows in the middle or makes a popping sound when a die is rolled through machine.
WARNING:
SAFETY GUARD MUST BE IN PLACE DURING OPERATION. KEEP
HANDS AND FINGERS CLEAR OF ROLLER OR
SERIOUS BODILY INJURY CAN OCCUR.
