Page 5
BEFORE USING FOR THE FIRST TIME
These instructions are important, and we request you read them before using this appliance.
They describe the appliance and the correct and safe way to use it.
Before connecting the appliance to the power supply, leave it standing for a least 8 hours. This
allows the refrigerant to drain back into the compressor and reduces the risk of malfunctions in
the cooling system caused by shipping.
Clean the appliance thoroughly, especially the interior. (See
Cleaning the Appliance
on page
12.) Proper grounding must be ensured to reduce the risk of shock and fire. Do not cut or
remove the grounding plug! Connect to a 120V, 60Hz grounded AC outlet having a minimum 15
amps. Do not use an extension cord. Use a three-prong plug with a three-prong grounded wall
outlet. If you do not have one, have a certified electrician install the proper outlet.
UNPACKING THE APPLIANCE
Remove tape and clean off any residual glue from the appliance surfaces before turning the unit on.
Apply some liquid dish detergent over the residue with your fingers, wipe down using warm water, then
dry.
In order to prevent damage to the surface of your appliance, do not use rubbing alcohol, flammable
fluids, abrasive cleaners or sharp tools when removing the packing tape and glue.
Discard or recycle all packaging material.
Clean the inside of your appliance prior to operation. Refer to the
Cleaning the Appliance
section on
pages 12 - 13.
ELECTRICAL REQUIREMENTS
Before moving your appliance into its desired location, it is important to check that the proper electrical
connection will be used.
Recommended grounding method:
A 115 Volt, 60 Hz., AC only, 15- or 20-amp fused, grounded electrical supply is required.
It is recommended that a separate circuit serving only your appliance be provided. Use an outlet that
cannot be turned off by a switch.
Do not use an extension cord.
Use a three-prong plug with a three-prong grounded wall outlet. If you do not have one, have a certified
electrician install the proper outlet.
NOTE: Be sure to unplug the appliance prior to installation, cleaning or general maintenance.
WARNING:
•
Plug into a grounded 3 prong outlet.
•
Do not remove ground prong.
•
Do not use an adapter.
•
Do not use an extension cord.
Failure to follow these instructions can result in fire, electrical shock or death.
