4
o
Air the room in which the unit isolated for several minutes, and
o
Contact the Service Department for advice.
•
The more coolant there is in a unit, the larger the room it should be installed in. In the event of a
leakage, if the unit is in a small room, there is the danger of combustible gases building up. For
every ounce of coolant, at least 325 cubic feet of room space is required. The amount of coolant
in the unit is stated on the data plate inside the unit. It is hazardous for anyone other than an
Authorized Service Person to carry out servicing or repairs to this piece of equipment.
•
Take serious care when handling, moving, and using the unit to avoid either damaging the
refrigerant tubing or increasing the risk of a leak.
•
Replacing component parts and servicing shall be done by factory authorized service personnel
so as to minimize the risk of possible ignition due to incorrect parts or improper service.
FOLLOW WARNING CALLOUTS BELOW
ONLY WHEN APPLICABLE TO YOUR
MODEL
• Use two or more people to move and install
unit
. Failure to do so can result in back or other
injury.
• To ensure proper ventilation for your
unit
, the front of the unit must be completely unobstructed.
Choose a well-ventilated area with temperatures above 60°F (16°C) and below 90°F (32°C). [For
optimal performance, install the unit where the ambient temperature is between 72º and 78ºF
(23º-26ºC).] This unit must be installed in an area protected from the elements, such as wind,
rain, water spray or drips.
• The unit should not be located next to ovens, grills or other sources of high heat.
• The unit must be installed with all electrical, water and drain connections in accordance with
state and local codes. A standard electrical supply (115 V AC only, 60 Hz), properly grounded in
accordance with the National Electrical Code and local codes and ordinances, is required.
• Do not kink or pinch the power supply cord of the unit.
• The size of the fuse (or circuit breaker) should be 15 amperes.
• It is important that the equipment be leveled in order to work properly. You may need to make
several adjustments to level it.
• All installations must be in accordance with local plumbing code requirements.
• Make certain that the pipes are not pinched, kinked or damaged during installation.
• Check for leaks after connection.
• Never allow children to operate, play with or crawl inside the unit.
• Do not use solvent-based cleaning agents or abrasives on the interior. These cleaners may
damage or discolor the interior.
• Use this equipment only for its intended purpose as described in this
Instruction Manual
.
• Keep fingers out of the “pinch point” areas. Clearances between the door and cabinet are
necessarily small. Be careful closing the door when children are in the area.
Risk of child entrapment!
Child entrapment and suffocation are not problems of the past. Junked or abandoned appliances are
still d
angerous, even if they will “just sit in the garage a few days.”
Before discarding your old refrigerator:
o
Take off the doors
o
Leave the shelves in place so that children may not easily climb inside
SAVE THESE INSTRUCTIONS
Содержание EQFF Series
Страница 15: ...15 NOTES...
