EXM-150 MICROSCOPE SERIES
ACCU-SCOPE
®
73 Mall Drive,
Commack, NY 11725 • 631-864-1000 • www.accu-scope.com
10
ADJUSTMENT & OPERATION
(continued)
Replacing the Rechargeable Batteries
1. Unplug the microscope from the electrical outlet
(if plugged in) and unplug charger from rear of microscope
(if plugged in).
2. Carefully place the microscope on the back of its arm so
the bottom of the microscope base is facing towards you.
3. To expose the battery compartment, open the trap door on
the bottom by unscrewing the lock screw
①
.
4. Using a small hex wrench, remove the screw
②
on the
battery compartment and slide the cover
③
toward you to
remove.
5. Replace the three NiMH AA 1300mAh rechargeable
batteries
④
.
6. Slide the cover back on and replace the screw.
7. Close the trap door and tighten the lock screw.
8. Carefully place the microscope in an upright position.
9. Plug the charger to the power receptacle on the back of
the microscope and plug into an electrical receptacle for
continued use while charging.
Allow the LED microscope to charge for 8 hours before using
as cordless.
Replacing the LED Bulbs
The life expectancy of the LED bulbs is 20,000 hours.
The LED bulbs are covered by a 1 year manufacturer’s
warranty.
Should your LED bulbs need replacing, please contact an
authorized ACCU-SCOPE service center or call ACCU-
SCOPE Inc.’s technical service department at
631-864-1000 for an authorized service center near you.
IMPORTANT
USE ONLY
AA 13
00mAh NiMH (Nickel Metal
Hydride) rechargeable batteries in your microscope.
Using any other type of battery may damage your
microscope
.
①
②
③
④
