Accton Technology WB3001A, Быстрое руководство по установке

Страница: 27 / 34

Troubleshooting
19
Troubleshooting
Check the following items before you contact Accton Technical Support.
1. If mobile users do not have roaming access to the WB3001A Wireless Bridge/
AP, check the following:
Make sure that all the WB3001As and wireless devices in the ESS in which the
WLAN mobile users can roam are configured to the same WEP setting, SSID,
and authentication algorithm.
2. If the WB3001A cannot be configured using the Web browser:
•Remove power from the WB3001A.
•Push in the reset button located on the back of the WB3001A.
•While holding in the button, apply power to the Bridge/AP.
•Wait until both the wireless Activity LED, and the wireless Link LED both start
to flash on and off together (about 5 seconds).
•Release the reset button and the LEDs will turn off. You are now in the Control
Mode.
•Select the desired function by pressing the reset button. Hold the button until
the LEDs change to the next configuration.
(The function changes to the next in sequence every time the reset button is
pressed.)
Control Mode will automatically terminate if the Bridge/AP does not detect the reset
button has been pressed for approximately 3 seconds. At that point it will flash both
LEDs twice, indicating it is proceeding with the boot.
Link LED Activity LED Action
OFF OFF No Action, will boot normally
OFF ON Revert to Factory Default settings.
ON OFF Force boot from Primary code image.
ON ON No Action, will boot normally