Accton Technology cheetahswitch workgroup-3024c, Быстрое руководство по установке

Страница: 11 / 19

Quick Installation Guide
5
5
Verifying Port Status
Check each connection by viewing the port status indicators shown in the following
figure and table.
LED State Indication
Power On Switch is receiving power.
Link/Act On Port has established a valid network connection.
Flashing Traffic is traversing the port.
100M On Communications have been set to at 100 Mbps.
FDX On Communications have been set to full duplex.
Verifying System Operation
Verify that all attached devices have a valid connection. The switch monitors the
link status for each port. If any device is properly connected to the switch and
transmitting a link beat signal, the Link indicator will light up for the corresponding
port. If the Link indicator fails to light when you connect a device to the switch,
check the following items:
•
Both sides of each connection must use the same transmission mode (i.e., half
or full duplex). If any device connected to an RJ-45 port must operate at full
duplex, be sure it supports auto-negotiation.
•
Be sure all network cables and connectors are properly attached to the
connected device and the switch.
•
See if your cable is functioning properly by using it for another port and
attached device that displays valid indications when connected to the network.
•
Be sure no twisted-pair cable exceeds 100 meters (328 feet).
Applications
This switch segments your network, significantly increasing both bandwidth and
throughput. Any port on the switch can be attached to a hub (i.e., shared collision
domain) or provide a dedicated link to a single network device (e.g., a
workstation). When a port on the switch is connected to a hub (i.e., a 10 or 100
Mbps repeater), the bandwidth provided by that port is shared by all the devices
connected to the attached hub. However, when a port is connected to an end
node or to a device that breaks up the collision domain (e.g., another switch,
bridge or router), the attached device has access to the full bandwidth provided
by that port.