Accton Technology Cheetah iSharer-3010, Руководство по установке

Страница: 14 / 22

Installation Guide
22 23
Cheetah iSharer-3010
Advanced
This page includes detailed settings for your modem. Please check the user’s
manual for your modem and fill in the respective data in the blanks.
Set “Dial on Demand” to “Enable” if you want the Cheetah iSharer-3010 to
automatically connect to the Internet when it receives any requests for Internet
service. You can also key in the retry timer for dialing into your ISP, and the idle
timeout for disconnecting the Cheetah iSharer-3010 from the Internet.
Set “Bandwidth Allocation” to “Enable” to force Modem2 to dial into your ISP when
Modem1 utilization exceeds the designated threshold.
Note: About ISDN TA Setup
Unlike most modems, ISDN initial strings vary between different ISDN TAs
and there is no “Standard ISDN TA” initial string. If your ISDN TA is not listed
in the modem selection list, you must find out your ISDN TA initial string. Your
ISDN TA’s initial string should be listed in your ISDN TA user’s manual. There
are probably many initial strings listed for your ISDN TA. The one you are
looking for is “Asyn-to-Syn PPP” (Asynchronous to Synchronous PPP). You
can enter this initial string if you want to use only one B channel of your ISDN
TA. If you want to bundle both B channels of your ISDN TA together, you need
to use a different initial string called “Multilink-PPP.” For example, the initial
strings for a Zyxel Onminet ISDN TA are:
1) ATB40: Asyn-to-Syn PPP initial string
(Refer to your ISDN TA manual.)
2) AT&J3: Multilink-PPP initial string
You should also verify that your ISDN TA supports the dial-up string ATDT.
Most ISDN TAs will support ATDT and the rest will usually support ATD or
ATDI.
Please also note that to bundle the two channels of your ISDN TA together,
you may need to enter the two phone numbers in the “Telephone Number”
field if your ISP has assigned separate phone numbers for each B channel.
Modem2 Setting
Settings for Modem2 are similar to Modem1. Please refer to the preceeding section.
Dial In Setting
Dial In User Account
To configure the Cheetah iSharer-3010 for remote dial-in access, please set
“Modem2 Dial-in Service” to “Enable”. Enter the ID and password for up to three
dial-in users. The default ID and password setting for user1 is “guest” and
“password.”