A111-003 Pulsed Coherent Radar
Operational description and User manual
Page 31 of 36
2022-01-04
© 2021 Copyright by Acconeer
The module may not be used to transmit data. The design does have data inputs and there is no
possibility for the user to modulate data on the transmitted signal
2.4 Limited module procedures
The A111-003 module has limited single-modular transmitter approval granted by FCC. Host product
manufacturers are responsible to follow the integration guidance and to perform a limited set of
transmitter module verification testing, to ensure that the end product is in compliance with the FCC
rules.
The host product manufacturer is responsible for compliance to any other FCC rules that apply to the
host not covered by the modular transmitter grant of certification.
2.5 Trace antenna designs
The product has integrated antennas in package, it is not possible to connect trace antenna.
2.6 RF exposure considerations
MPE RF exposure testing is not needed as the available maximum time-averaged power of the module
is no more than 1 mW, according to 47 CFR 1.1307(b)(3)(i)(A). Co-location of this module with other
transmitters that operate simultaneously are required to be evaluated using the FCC multi-transmitter
procedures.
2.7 Antennas
The modular approval covers use with dielectric lens that converge or diverge the electromagnetic
waves at least in one plane of radiation (E or H plane).
2.8 Label and compliance information
The host device shall be labelled to identify the modules within the host device, which means that the
host device shall be labelled to display the FCC ID of the module preceded by words "Contains
transmitter module" or "Contains", E.g.
Contains FCC ID: 2AQ6KA1003
If the module is installed such that it is not visible (e.g., behind the headliner), then the required
equipment labeling in accordance with the provisions of 47 CFR §§ 2.925 and 15.19 shall be provided
in the vehicle’s Owner’s Manual.
The module integrator must include below interference statement to vehicle Owner's manual:
This device complies with Part 15 of the FCC rules. Operation is subject to the following two
conditions: (1) this device may not cause interference, and (2) this device must accept any
interference, including interference that may cause undesired operation of the device.
2.9 Information on test modes and additional testing requirements
Testing for the modular approval of the A111-003 has been performed using a binary file which
represents highest Tx emission configuration. This test binary is available in the software provided by
Acconeer and can be used for that the module as installed in a host complies with FCC requirements.
2.10 Additional testing, Part 15 Subpart B disclaimer
The host product manufacturer is responsible for compliance to any other FCC rules that apply to the
host not covered by the modular transmitter grant of certification.
