Installation
Service
WARNING:
Do not attempt to service or repair
the laminator. Failure to observe this warning could
result in severe personal injury or death.
Disconnect the plug from the receptacle and contact
Customer Service when one or more of the following
has occurred.
•
The power supply cord or attachment plug is
damaged.
•
Liquid has been spilled into the laminator.
•
The laminator is malfunctioning after being
mishandled.
•
The laminator does not operate as described in
these instructions.
Installation
•
Shipping damage should be brought to the
immediate attention of the delivering carrier.
•
Place the laminator on a stable flat surface or
table capable of supporting 75 lbs.
•
The
surface should be at least 30” high to
assure comfortable positioning during
operation. All four rubber feet should be on the
supporting surface.
•
Connect power cord to an appropriate power
source. Avoid connecting other equipment to
the same branch circuit to which the laminator
is connected as this may cause nuisance
tripping of the circuit breaker or blown fuses.
•
The laminator should be positioned to allow
exiting film to drop freely to a flat surface.
Accumulation of laminated documents as they
exit the laminator may cause a jam.
•
Avoid placing laminator near sources of heat or
cold. Avoid locating the laminator in the direct
path of forced, heated or cooled air.
Caring for Ultima 35
The only maintenance required by the operator is to
periodically clean the heatshoe. This can be done by
waiting for the machine to cool completely and then
wiping the heatshoe with a damp, lint free cloth.
Keeping the heatshoe clean ensures that your finished
items will not be damaged by dirt and adhesive build-
ups.
WARNING:
Do not apply cleaning fluids or
solvents to the heatshoes or rollers.
WARNING:
Do not attempt to laminate
adhesives
marked ‘Flammable’.
WARNING:
Do not expose laminator to liquids.
1.
Remove the film from the laminator following the
procedure outlined in the section FILM LOADING
AND THREADING.
2.
Clean the heatshoe with a clean, damp, lint-free
cloth. If there are any adhesive build-ups, you
may use isopropyl alcohol instead of water.
3.
Follow the procedure in section FILM LOADING
AND THREADING, Method Using Film Threading
Card to reload the laminator.
Note:
Do not use metal scouring pads to clean the
heatshoe!
WARNING:
Do not laminate glitter and/or
metallic items. Damage to the heatshoe may result.
The side covers and feed table can be cleaned with a
lint-free cloth and a mild detergent.
