Acclaim Lighting Linear One DMX Exterior, Руководство пользователя

Страница: 16 / 28

14
www.acclaimlighting.com
Terminator plug
[Part #: LXTEC]
TIPS FOR ACHIEVING SUCCESSFUL DMX CONTROL
•
Do not exceed a total cable length of 3,900 ft (1200m) or a total of 32 fixtures on a single
line without signal boosting. An Acclaim Lighting RDS-6 RDM splitter or equal device can
be used for this purpose.
•
Attach a terminator plug [Part #: LXTEC] to the output connector of the final fixture. The
terminator plug will correctly terminate the DMX signal:
•
The DMX cable connected to the feed cable should be suited for RS-485 data transmission
and have a characteristic impedance of 120 ohms, such as Belden 9842 or equivalent.
•
Do not introduce a passive Y-split into the control cabling. If it is necessary to split the
control link in order feed fixtures located in different directions, use a powered DMX
splitter such as the Acclaim Lighting RDS 6:
https://acclaimlighting.com/rds-6
•
Ensure that the DMX + and DMX – connections do not become crossed at any point.