• Do not open batteries;
• Do not charge damaged batteries.
• Do not dispose of used batteries with household waste.
• Do not expose the battery to flame, intense heat or light;
If leakage of the electrolytic mass from the battery is detected, follow these steps:
1) Gently wipe the liquid off the surface of the battery using a piece of cloth. Avoid contact of liquid with skin;
2) In case of skin contact, rinse immediately with plenty of water. You can neutralize battery fluid with a mild
acid, such as lemon juice or vinegar.
3) In case of contact with eyes, flush eyes with plenty of clean water for at least 10 minutes. Then see a doctor.
EXPLOITATION
1. PREPARATION FOR WORK
The cordless drill comes with a partially charged battery. Charge it before use. The lithium-ion battery can be
recharged at any time without any reduction in service life.
1) Plug the charger into an electrical outlet. The glow of the green indicator indicates the operability of the
charger.
2) Insert the charger plug into the battery connector, the green indicator will turn off, the red indicator will
light up, the battery charging process will begin.
3) At the end of charging, the red indicator will turn off, the green indicator will light up - the battery is fully
charged. If the indicator lamps on the battery do not light up or light up in other combinations, unplug the
charger from the socket, check the condition of the battery case and the correct connection of the charger to
it.
4) When charging is complete, disconnect the charger cable from the battery and unplug the charger from the
mains.
5) Insert the battery into the tool handle until the lock clicks into place. Always insert the battery all the way
until it clicks into place. If this is not done, the battery may suddenly fall out of the tool. Do not use force when
inserting the battery. If the battery is difficult to insert, then you are doing something wrong.
6) To remove the battery, press the battery lock buttons located on the sides of the battery and, holding the
handle firmly, pull the battery out of the tool handle.
Note.
Approximate battery charging time based on 20°C temperature. The charging time increases when the
air temperature drops, or in case of insufficient voltage in the mains. The battery and charger may become
slightly warm during charging, this is normal and does not indicate a malfunction.
Attention
. If the battery does not charge properly, follow these steps:
1) make sure that there is voltage in the power supply by connecting some other electrical appliance;
2) check all power cable connections;
3) move the charger with the battery to a room with optimal temperature conditions;
4) if the problem remains, contact an authorized service center for assistance.
1. WORKING IN THE SCREWDRIVER MODE
• Set the adjusting ring to the correct torque level for your job.
• Install a screwdriver bit in the chuck that matches the screw/screw/bolt being used.
