Accessmatic Eagle 500, Руководство пользователя

Страница: 45 / 60

Instalation:
1) Open the cover and connect wires.
2) Mounted the receiver and transmitter on the proper position.
3) Ensure there are no obstacles between receiver and transmitter.
For optimal efficiency, the receiver and transmitter should be properly aligned.
4) Power-up the photocells and make sure the LED light on receiver and transmitter are ON.
Step 1 Step 2 Step 3 Step 4
Get Started
Step 1: Remote Memorizing
Memorizing
Note:
A) Transmitter memorizing must be done first before system learning.
B) CHECKING THE Gate MOVEMENTS
1) Release the gearmotor with the release key and move the gate to the middle so that it is free to move in both opening
and closing directions; then lock the gearmotor.
2) Perform the gate opening and closing several times and make sure the gates touches the limit switch at least 2~3 cm
before the mechanical stop.
Press button RF-Learn on the control board (Figure 1) as many times as the number corresponding to the desired
command, according to the following table, Within 10s, press the desired button on the remote that you want it to be
memorized (figure 1)
(Figure 1)
(Figure 2)
Transformateur
Pantalla LED
LED 2 – Le bouton-poussoir
et le sélecteur à clé
LED 4 – Photocellule 1
LED 3 – Photocellule 2
9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26
(UP)
(SET)
(DOWN)
(RF-LEARN)
LED2 LED4 LED3
11
Lmt2 GND Lmt3Lmt4 GND GND Ph1 Ph2 PhVcc PhVcc GND DKeySKey
LED2 Push button or
key selector
LED4 Photocell 1
LED3 Photocell 2
Command
Open - Stop - Close circle
Pedestrian mode
LED display “OSC”
LED display “PED” 1 vez
2 veces
Times for
pressing
RF-Learn
Command Message code
1 13
Opening your life
AC24NE