REPLACEMENT PARTS
3V CR2032 Lithium battery . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .10A20
Visor Clip . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .29B137
ONE YEAR LIMITED WARRANTY
The Chamberlain Group, Inc. warrants to the first consumer purchaser of this product that it is free
from defect in materials and/or workmanship for a period of 1 year from the date of purchase.
3-BUTTON REMOTE CONTROLS
Press and hold the button down until the door or gate starts
to move. The remote control will operate from up to 3 car
lengths away on typical installations. Installations and
conditions vary, contact an installing dealer for more
information.
NOTICE: To comply with FCC and or Industry Canada rules (IC), adjustment or modifications of this
receiver and/or transmitter are prohibited, except for changing the code setting or replacing the battery.
THERE ARE NO OTHER USER SERVICEABLE PARTS.
Tested to Comply with FCC Standards FOR HOME OR OFFICE USE. Operation is subject to the following
two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
3V CR2032
Pry open the case first
in the middle (1), then
at each side (2 and 3)
with the visor clip.
Remove the old battery.
Dispose of old batteries
properly.
Insert replacement
batteries positive side up.
Replace the batteries
with only 3V CR2032
coin cell batteries.
Replace cover.
THE REMOTE CONTROL BATTERY
The lithium battery should produce power for up to 3 years. If the battery is low, the remote control's LED will
not flash when the button is pressed. To replace battery:
To prevent possible SERIOUS INJURY or DEATH:
• NEVER allow small children near batteries.
• If battery is swallowed, immediately notify doctor.
To reduce risk of fire, explosion or chemical burn:
• Replace ONLY with 3V CR2032 coin batteries.
• DO NOT recharge, disassemble, heat above 212° F (100° C) or incinerate.
© 2014, The Chamberlain Group, Inc.
114A4729
All Rights Reserved
1-800-528-9131
www.liftmaster.com
1
2
3
HOW TO USE THE REMOTE CONTROL
Additional buttons on the remote control can be
programmed to operate up to 3 devices such as additional
garage door openers, light controls, gate operators or
access control systems.
TO CONTROL THE GARAGE DOOR OPENER LIGHTS
With the door closed,
press and hold
the remote
control button
that you want to
control the light.
Press and
hold the
LIGHT button
on the
door control.
+
Press and
hold the
LOCK button
on the
door control.
After the garage
door opener
lights flash,
release all
buttons.
+
“click”
“click”
This feature is only available on garage door openers equipped with a multi-function door control and a remote control with more than one button. Not available with external receiver.
A remote control button can be programmed to operate the garage door opener lights without opening the door.
Test by pressing the remote control button. The garage door opener lights should turn on or off but the door should not move.
