3
A. The cover comes pre-rolled to its
normal open position for ease of instal-
lation. Set pre-rolled cover on tailgate
with front bar facing up as shown. Align
EZ-Dial Tension Adjuster (marked L)
on driver side of cover - positioned as
shown in photo at left.
2. ASSEMBLING TENSION ADJUSTERS TO COVER
B. Turn 1-1/4” bolt with flat washer
onto nut in bar. Leave loose for now.
See
photo.
Repeat for EZ-Dial (R) on pas-
senger side of cover, and leave that bolt
loose also.
C. Next install a 2nd clamp at midway
point of box and rail. Now check rail for
level.
See photo at left and illustration below.
If rail tilts up, move clamps down and
tighten. If rail tilts down, move clamps
up and tighten.
1. INSTALLING COVER SIDE RAILS CONT’D.
Second
clamp
D. Install third clamp as close to tailgate
as possible.
See photo.
Make sure all clamps
are placed in best up or down position
for a level rail. Then recheck all clamps
to insure adequate tightness.
Third clamp last
Nut
“L” Left
EZ-Dial
Working from front to tailgate
match this point of cover rail
with top of pickup box as
clamps are installed
This part of rail
should be near
level
Inside lip of box
Adjust clamps
up or down
until they
hold rails
level when
tightened
