Accell Currie Tech IZIP Tricruiser Скачать руководство пользователя страница 5

Страница: 5 / 6

Customer Support: 1-800-377-4532

Revised: June 15, 2012 9:04 AM

Step 2

Find the front-rear transfer chain you removed in the preparation section of this guide.

Wrap the chain around the two free cogs, then re-assemble the master link. Close the master link with a pair of

needle-nose pliers.

Adjust the tension of the transfer chain by sliding the rear end towards or away from the main frame; when properly

adjusted the chain should have about 1/8in (3mm) of vertical play. Be sure the rear axle remains perpendicular to

the frame.

Step 3

Make sure the front and rear frame sections are perpendicular to each other. Tighten the four carriage bolts from

step 1, then re-check the rear-end alignment and transfer chain tension.

Step 4

a) Re-attach the rear wheels. Notice that one rear axle has a flat section, while the other does not. This prevents

the wheels from being incorrectly installed. Attach the rear wheel hardware as shown in the diagram, then tighten

the four axle nuts securely with a 17mm wrench.

b) Re-attach the fenders and basket, referring to the images in step 1 of the “preparation” section of this guide if

needed.

Hub (left)

Hub (right)

Washer

Washer (large)

Nut

Locknut

Washer (small)

Содержание Currie Tech IZIP Tricruiser






