Accel FX22 Command center, Руководство пользователя

Страница: 6 / 14

6
(1) BANK DN
BANK DOWN switch 1(SW1);
In “Recall Mode”
, press this switch to decrease the bank number.
In “Program Mode ”, hit this switch to shift the programming between loop1~4 (“L” in LCD Display ) and loop5~8 (“H”
in LCD Display).
To toggle between
“
Recall Mode
”
and
“
Program Mode
”
hold this switch down for a couple seconds. Check for more
details in the
“P
rogramming Loops and Foot switches
”
section (page 4).
(2) BANK UP
BANK UP switch (SW2);
In
“Recall Mode”
, press this switch to increase the bank number.
In
“Program Mode”
, press this switch to program the amp footswitches (FS1/FS2). Holding down this
switch will toggle between
“Recall Mode”
and
“Active Bank Setup Mode (ABS)”
, for more complete of
the
“ active bank setup mode” (page 5).
(3) A B C D
In Recall Mode:
Preset switches
“A” “B” “C” or “D” recall previously programmed loops for those switches.
(Pressing the same preset switch again will
“Bypass” the switcher, as indicated by the blue led above the bank up
switch).
In Program Mode ,
“
A
”
engages loop4 or loop8,
“
B
”
for loop3 or loop7,
“
C
”
for loop2 or loop6,
“
D
”
for loop1 or
loop5.
(4) TUNER / Mute
When this switch is engaged, the OUTPUT jack will be muted and the TUNER jack connects to INPUT jack.
(5) NUMERICAL (LCD) DISPLAY
In Recall Mode:
The numerical display indicates the active BANK.
In Program Mode:
“L” indicates loop1~4 are ready to be programmed, “H”
indicates loop5~8 are ready to be programmed.
In “Active Bank Setup” (ABS) Mode:
A blinking “Blue LED” above “Bank Up” indicates the ABS program mode has been activate. (See the “ABS Section on
page 5 for programming the ABS Function).
(6) Master Bypass Access
To bypass the effects looped into the switcher, simply press any active recall switch
“A, B, C, D” (the active switch will be indicated by a solid red LED above the switch). When this switch is
pressed again, that switches LED will turn off. A
blue LED above the “BANK UP” switch will turn solid blue.
This will indicate that the switcher is in “Bypass Mode”. Select any switch A-D to exit bypass mode and enter
back into recall mode. (You cannot program the switcher in bypass mode).