AEC-6896S/6896 Manual
12
3.1.2 Build Mirror Disk
When replacing a mirrored hard drive, you can rebuild the hard drive’s data by
“Build Mirror Disk” according to the prompt upon booting. Please see 3.2.2.
3.1.3 Quick Erase Disk
This function allows you to quickly erase the data on a selected hard drive. Beware
that the data and the partitions will be erased.
3.1.4 RAID Mode Help
This function chiefly tells you that RAID 0+1 requires 4 hard drives. If your hard
drives are ATA ones, you are strongly recommended to set the disk jumper as CS
(cable selection).
3.1.5 Card Information
This function indicates the I/O address, ROM address and IRQ number currently
used by AEC-6896.
3.1.6 Set Boot Disk
This function lets you select a hard drive or an array containing OS to boot. But you
need to enter BIOS of the motherboard, then boot “Other Boot Device”. If a hard
drive has been set as boot disk, there will be a * appearing before its model number.
3.2 Setting of RAID Mode
NOTICE: The rebuilding time depends on the size of RAID. You can press
Ctrl + S to stop rebuilding.
AEC-6896 supports RAID 0, 1, 0+1 and JBOD modes. The hardware setting re-
lated to each RAID mode is briefly described below. Yet, you are suggested to use
the AEC-6896 RAID Utility to set RAID. Please refer to Chapter 5 and Appendix A.
