• You can charge the battery by plugging the USB cable into
any of the power supplies listed below:
• A computer
• A USB wall-charger with an output of 5 volts and 1 amp
• A DC car-charger with an output of 5 volts and 1 amp
• It takes about 3-4 hours to fully charge the battery from
empty. Try not to let the battery completely run out before
charging. Charge the battery as needed.
• A fully charged battery can provide up to 16 hours of
working time in normal brightness and up to 40 hours in low
brightness mode.
• To check remaining battery level, see “Battery Level
Indicator” section.
* Note: Using a “fast-charging” charging block or charging hub (a charging block/hub delivering
over 5v at 1A) could damage your Acaia scale’s circuit board.
Turn on the Acaia
scale.
Make sure the scale
is in weighing mode
and the unit is set to
‘gram’, then tap the
‘T’ button rapidly.
Keep tapping the ‘T’
button until ‘CAL’ is
shown on the
display.
Place a weight
(100 g/500 g/1000 g)
on the scale and wait
until the display
shows ‘_End_’.
Calibration is now
complete!
Product Care Information
Turn on scale
Tap Tare button
See CAL display
Place a weight
Battery Charging
Calibration
7
Battery Indicator
• When the scale is off, the remaining battery level can be viewed by pressing and holding
the power button until the battery level indicator is displayed.
• You can also check the battery level by connecting the scale to Acaia Apps.
