Technical Information
ƴ
12. TURBO Button
Press this button to activate/deactivate the TURBO function which enables the unit to reach the preset temperature in
the shortest amount of time. In COOL mode, the unit will blow cooling air at a high fan speed. In HEAT mode, the unit
will blow heating air at a high fan speed.
13. X-FAN | Button
For use in COOL or DRY mode: Pressing this button will activate the fan at low speed for 2 minutes in order to dry the
indoor unit, the unit will then completely power down. On unit start-up, the X-FAN feature is defaulted to OFF. X-FAN
feature is not available in AUTO, FAN or HEAT modes.
14. I FEEL Button
Press this button to start I FEEL function. The unit will automatically adjust the temperature according to the sensed
temperature. Press this button again to cancel the I FEEL function.
15.
Button (This function is not available on all models).
Press this button to achieve the on and off of healthy and scavenging functions inoperation status. Press this button
for the first time to start scavenging function, LCD displays . Press the button for the second time to start healthy
and scavenging functions simultaneously, LCD displays . Press the button for the third time to quit healthy and
scavenging functions simultaneously. Press the button for the fourth time to start healthy function, LCD displays .
Press this button again to repeat the operation above. (This function is applicable to partial of models).
Function Introduction for Combination Buttons
Pressing
S
and
T
buttons simultaneously to lock or unlock the keypad. If the remote controller is locked, is displayed.
While this icon is displayed, pressing any button will cause the icon to blink three times.
While the unit is OFF; press MODE and
T
buttons simultaneously to switch between Cº and Fº.
While the unit is in COOL mode, press TEMP and CLOCK simultaneously to initiate energy saving mode. The remote
controller will display SE. Press TEMP and CLOCK simultaneously again to quit energy savings mode.
In heating mode, press the TEMP and CLOCK buttons simultaneously to start or turn off the 8ºC/46ºF heating function.
When this operation starts, and 8ºC/46ºF will be shown on the remote controller and the air conditioner will keep the
heating status at 8ºC/46ºF.
Operation Guide
1. Press ON/OFF button on the remote controller to turn on the air conditioner.
2. Press MODE button to select the desired operation: AUTO, COOL, DRY, FAN, HEAT.
3. Press
S
and
T
button to set your desired temperature. (Temperature cannot be adjusted in AUTO mode).
4. Press FAN button to set the desired fan speed: AUTO, LOW, MEDIUM and HIGH.
5. Press SWING button to select fan blowing angle.
Replacement of Batteries in Remote Controller
1. Press the back side of remote controller marked with , as shown in the figure on the right, and then push out the cover
of the battery box.
2. Replace the two AAA batteries with fresh AAA batteries, making sure to position them on the correct polar sides “+” and
“-“.
3. Reinstall the cover of the battery box.
NOTE:
• Aim the signal sending end (top) of the remote controller at the unit to operate.
• Distance between the unit and the remote controller should be no more than 20 feet and there should be no obstacles in
between them.
• Remote controller signal may be interfered in the present of fluorescent lighting or wireless telephones.
• Replace batteries when remote control signal is weak or when display becomes fuzzy or difficult to read.
• Remove batteries during prolonged periods of time where the controller will not be used.
battery
Cover of battery box
remove
reinstall
Содержание AWH18QD-D3DNA1G/O
Страница 2: ......