AC Infinity AIRTAP T4, Руководство пользователя

Страница: 8 / 11

14 15
PROGRAMMING
HEATING TRIGGER
This allows you to set a temperature trigger for the fan to run when your
central heating system is on. In this mode, you can set a temperature
that will trigger the fan to run when the probe temperature meets
or exceeds the set temperature. And trigger OFF when the probe
temperature falls below the set temperature. To minimize noise and
power consumption, we designed it so that the fan speed will slowly
ramp up towards the set fan speed or slowly ramp down to turn off. While
in this mode, you can press up or down to change the set temperature.
You can also hold the MODE button simultaneously for 2 or more
seconds to turn this trigger off, in which the display will show “OF".
If the fan is not running when it should be, you may need to raise the set
temperature. If the fan is running when it shouldn't be, you may need to
lower the set temperature.
After setting the temperature triggers and fan speed, it is recommended
to return to the temperature display mode. You can do this by pressing
the MODE button to cycle through the modes until you reach the
temperature display mode.
FAN SPEED
This allows you to set a max speed the fan
can reach when the cooling or heating triggers
the fan to run. While in this mode, press the up
or down button while in this mode to change
the speed. Ideally, you would chose the
highest fan speed in which you can tolerate
its noise comfortably. Holding MODE button
simultaneously for 2 or more seconds will set
the fan speed to zero.
FAHRENHEIT OR CELSIUS
The temperature displayed can be set to
Fahrenheit or Celsius scale by holding the
up and DOWN button simultaneously until
˚F or ˚C is shown after the digits. All digits
displayed will be automatically converted
to the designated scale.
PROGRAMMING