abyzz A100, Руководство по эксплуатации

Страница: 15 / 32

Operation
In the "Permanent" operating mode (set when delivered), you can use the start/
stop button to start or stop the motor. You can adjust the speed using the up and
down buttons. If you want to store the new speed permanently, press "M". The set
value is then retained by the system. The start/stop setting is stored automatically
so that the pump automatically starts in its previous operating mode following an
interruption in the operating voltage or if the mains switch is switched off.
If you want to enter the menu to view operating data or to program the pump,
press "M".
The menu appears and the current operating mode is displayed. Use the up and
down buttons to navigate in the menu. The software status, operating hours, and
operating mode are displayed one after the other.
The contrast of the display may be adjusted in the screen „Software & Kontrast“ by
keeping the „Start/Stop“ button pressed and pressing the buttons „up“ or „down“.
If you want to change the operating mode, press the start/stop button on the
operating mode display. You can now use the up and down buttons to change the
operating mode. There are the following operating modes:
a) Permanent: The pump runs continuously at a set speed.
b) Wave: The pump switches between two different set speeds at a set interval.
c) Random: The pump changes speed within a range defined by a minimum and
maximum value at a set time.
d) Random 2: The pump changes speed within a range defined by a minimum
and maximum value at a random time.
Once you have selected the operating mode, press the start/stop button. You are
then asked to enter the required data (minimum and maximum power, time
interval). Confirm each setting by pressing the start/stop button. When you are
finished, the settings are saved automatically and the system returns to the
overview.
15