9
4.2 Status LEDs
LED Farbe
Bedeutung
Status LED
Red continuously on
Start up procedure (boot procedure)
In case a network cable is attached to the
camera, the camera will try to assign a valid IP
address (using DHCP or using the configured
fixed IP address).
In case wireless network is configured, the
camera tries to connect to access point using
the configured wireless SSID/encryption.
Red flashing 1 /
second
Network connection is not available.
LAN: network cable not connected or defect
Wireless: configured wireless data is not
accepted by the access point, or the access
point is out of range.
Blue continuously on
IP address was assigned successfully. (Note: it
could be possible that the IP address will not
match the target network. This can happen on
manual setting of IP address.
WPS LED
Flashing 1 / second
WPS search started (pressing the WPS button
for more than 10 seconds). The camera will try
to exchange the wireless encryption settings
with the WPS activated access point/Router.
4.3 Restoring the factory settings
Camera restart
Press the reset button for a short time. The camera will
reboot.
Restoring the factory settings
Press the reset button for more than 10 seconds. The
settings of the camera will be reset to factory default.
This is especially required after a firmware upgrade.
