13
7.7. Use the Allen key provided to tighten the 4 screws on the
top of the camera.
The upper cover of the camera must fit the camera
housing completely. All 4 screws must be fully tightened.
Only this will guarantee that the camera is completely
waterproof.
Place and fix the sunroof if used.
8. Installation
Proceed as follows when installing the camera.
1. Select a suitable place to mount the camera.
2. Connect the video cable (recommended cable type: RG59) with the BNC
video output (1) of the camera and with the output of the camera as the next connected device.
The maximum cable length must not exceed 200 m.
3. Connect a 12V DC voltage supply to the power input
of the camera (2).
4. Hold the camera at the location where you want to mount it later.
change. Check the orientation and angle of the camera.
5. Fasten the supplied wall or ceiling mount (4) to the desired installation location and
screw the mount into the camera housing (3).
6. Change the orientation of the camera holder if necessary by slightly loosening the fixing
screw (5) and changing the position as required. Then tighten the fixing screw so that the
camera remains in the desired position.
Important:
You can remove the sunroof by loosening the fixing screws (6).
