– 39 –
GB
Installation and operation
In order to mount the alarm on the ceiling, follow the steps in the order listed
below:
1. Remove smoke alarm from the cover base
by turning anti-clockwise.
2. Remove the locking pin located in the
mounting socket (
further use in step 6,
is used for unintentional disassembly
).
3. Mark the holes through the cover base.
4. Fit the required dowels into the drill holes
and tightly screw in the detector base.
When marking out your drill holes, ensure that no electrical wires
cables, pipes or other installation components are located behind
the installation point!
5. Attach smoke alarm by turning clockwise at the detector base. Small markings
are found on the side of the detector base and on the alarm itself which make
it easier to fit the alarm onto the base (see illustration on page 40).
To be ready
for operation, the detector must snap into the socket!
6. Insert the locking pin from step 2 into the designated side opening to prevent
the alarm from turning (see illustration on page 40).
Installation and operation
