ABT 7100
– Issue 02
6
4.2
Assembly
•
Place the
wheel arm labelled ‘
L
’ and the
fixed end of the track geometry trolley side by side as
shown in Figure 1.
•
Push the locating pins at the end of the trolley body into the corresponding slots on the wheel
arm.
•
Once they are placed square, push the wheel arm attachment screw inwards and start
tightening the screw in clockwise direction using the knob. When tightened there should be no
gap between the two parts and they should be secure.
•
Repeat the same process for the right-
hand side wheel arm (labelled ‘
R
’) and the sprung end
side of the trolley (Figure 2).
Figure 1 Attaching wheel arm to trolley (Left side)
Figure 2 Attaching wheel arm to sprung end of the trolley
(Right side)
